Start practice — 8 questions →
Sample questions
What personal protective equipment (PPE) is required for all other applicators and handlers when using this product?
- Filtering facepiece respirator (N95, R95, or P95), waterproof gloves, and long-sleeved shirt
- Long-sleeved shirt, long pants, waterproof gloves, and shoe plus socks
- Goggles, long-sleeved shirt, long pants, and chemical-resistant apron
- Filtering facepiece respirator, long pants, and waterproof gloves
Show answer
All other applicators and other handlers must wear: long-sleeved shirt and long pants, waterproof gloves, and shoe plus socks.🔗 Source
To reduce the potential for runoff, when should applications of Vangard WG be avoided?
- When wind speeds exceed 10 mph
- When temperatures are above 90 degrees
- When rainfall is forecasted to occur within 48 hours
- When humidity is above 80%
Show answer
Avoid applications when rainfall is forecasted to occur within 48 hours to reduce runoff potential.🔗 Source
According to the label, what is the active ingredient concentration and its FRAC group for Vangard WG?
- Cyprodinil (50.0%), FRAC Group 1
- Cyprodinil (75.0%), FRAC Group 9
- Cyprodinil (75.0%), FRAC Group 4
- Cyprodinil (85.0%), FRAC Group 9
Show answer
The active ingredient is Cyprodinil (75.0%), which belongs to FRAC Group 9.🔗 Source
What specific respiratory protection is required for mixers and loaders performing aerial and groundboom applications?
- A full-face respirator
- An N95, R95, or P95 filtering facepiece respirator
- A chemical vapor cartridge respirator
- A dust mask only
Show answer
In addition, mixers and loaders for aerial and groundboom applications must wear a filtering facepiece respirator (N95, R95, or P95).🔗 Source
Which statement regarding the application of Vangard WG is true based on the label instructions?
- It can be applied as a full spray, in block, alternating spray, or tank-mix programs.
- It can only be applied via groundboom sprayers.
- It must only be applied as a preventative spray.
- It is strictly prohibited for use in nut crops.
Show answer
It is a water-dispersible granule designed for foliar applications, which can be applied as a full spray or used in block, alternating spray, or tank-mix programs.🔗 Source
How should resistance management be handled when using Vangard WG?
- By increasing the application frequency of the same product
- By using only high-dose applications
- By rotating with fungicides from different FRAC groups and integrating it into an IPM strategy
- By mixing it with other FRAC Group 9 fungicides only
Show answer
For resistance management, it is recommended to rotate Vangard WG with fungicides from different FRAC groups and integrate it into an overall Integrated Pest Management (IPM) strategy.🔗 Source
What is the Reentry Interval (REI) for this product?
- 6 hours
- 12 hours
- 24 hours
- 48 hours
Show answer
REI: 12🔗 Source
Which of the following is a stated environmental hazard for Vangard WG?
- It is toxic to bees and beneficial pollinators
- It is toxic to fish and aquatic invertebrates
- It is harmful to soil microbes
- It causes significant groundwater contamination
Show answer
It is toxic to fish and aquatic invertebrates; avoid application near water or areas where surface water is present.🔗 Source
← All practice exams