Start practice — 8 questions →
Sample questions
When treating indoor spots, general surfaces, or cracks and crevices, what is the specified application rate?
- 1 gal. per 1,500 ft2
- 2 gal. per 1,000 ft2
- 1 fl. oz. per gal. of water
- 0.5 fl. oz. per gal. of water
Show answer
For Indoor Spot, General Surface, or Crack and Crevice, the rate is 2 gal. per 1,000 ft2.🔗 Source
When treating carpets, furniture, and pet sleeping areas, what is the required dilution rate?
- 1.0 fl. oz. per gal. of water
- 0.5 fl. oz. per gal. of water
- 2.0 fl. oz. per gal. of water
- 1.0 fl. oz. per 1,500 ft2
Show answer
The label specifies a dilution of 0.5 fl. oz. per gal. of water for carpet, furniture, pet sleeping areas, and throw rugs.🔗 Source
Which of the following is a prohibited application method according to the label restrictions?
- Injecting into cracks and crevices
- Using a ULV spraying device
- Spraying into the air
- Applying as a carpet shampoo
Show answer
The restrictions state: 'Do not spray into the air; only spray onto the specific use sites.'🔗 Source
What is the restriction regarding children and pets after a treatment has been applied?
- They may enter immediately if the area is ventilated
- They must stay out until the area is vacuumed
- Do not allow them into treated areas until spray has dried
- They can enter after 24 hours regardless of dryness
Show answer
The label states: 'After treatment, do not allow children and pets into treated areas until spray has dried.'🔗 Source
When preparing a diluted spray solution specifically for FLEAS AND TICKS, how much Tekko Trio should be added per gallon of water?
- 0.5 fluid ounce
- 1.0 fluid ounce
- 1.5 fluid ounces
- 2.0 fluid ounces
Show answer
For fleas and ticks, the label instructs to add 0.5 fluid ounce Tekko Trio per gallon of water.🔗 Source
When using an appropriate ULV spraying device to treat wall voids, how much space will the resulting 2 fl. oz. of injection solution treat?
- 1,000 cubic feet
- 1,500 cubic feet
- 1,900 cubic feet
- 2,000 cubic feet
Show answer
The label states that the resulting 2 fl. oz. of injection solution will be used to treat 1,900 cubic feet of space.🔗 Source
When performing a foam application into wall, equipment, or other small structural void areas, what is the dilution rate?
- 0.5 fl. oz. per gallon of diluent
- 1.0 fl. oz. per gallon of diluent
- 1.0 fl. oz. per 1,500 ft2
- 2.0 fl. oz. per gallon of diluent
Show answer
For foam application, the label specifies a dilution of 1.0 fl. oz. per gallon of diluent.🔗 Source
According to the restrictions, what must be done with pets before spraying a treatment area?
- Keep pets in a separate room during application
- Remove pets prior to spraying treatment area
- Ensure pets are wearing protective gear
- Only remove pets if they are fleas or ticks carriers
Show answer
The restrictions explicitly state to 'Remove pets prior to spraying treatment area.'🔗 Source
← All practice exams