Start practice — 8 questions →
Sample questions
What must be done to a surface before applying this gel bait if a repellent insecticide has been used there?
- The surface must be left alone
- The surface must be thoroughly washed
- The surface must be heated to 130°F
- The surface must be covered with food-grade plastic
Show answer
The label states do not apply in areas where repellent insecticides have been or will be used without thoroughly washing the surface.🔗 Source
Where is a strictly prohibited application site for this product regarding aircraft?
- In the passenger cabin
- In the cargo hold
- In cockpit areas
- In the lavatories
Show answer
The restrictions state: 'DO NOT APPLY ANY BAIT IN COCKPIT AREAS OF AIRCRAFT.'🔗 Source
In which of the following locations is the bait permitted for use in a food handling establishment?
- On food preparation surfaces
- On kitchen utensils
- In nonfood areas like garbage rooms or lavatories
- On food containers
Show answer
The label specifies use in nonfood areas such as garbage rooms, lavatories, and offices, but prohibits use on food preparation surfaces or utensils.🔗 Source
Which of the following pests is NOT a target pest for Sumari Ant Gel Bait?
- Carpenter ants
- General ants
- Ants in residential areas
- Ants in industrial areas
Show answer
The label explicitly states the product is for ants excluding fire ants and carpenter ants.🔗 Source
According to the label, what is the only approved application method for this product?
- Broadcast spraying
- Mist application
- Spot and crack and crevice application
- Drenching and soaking
Show answer
The restrictions state: 'Only for spot and crack and crevice application.'🔗 Source
When applying the bait to food handling areas, how should the dispenser tip be positioned?
- On the surface of the food preparation area
- Approximately 1/2 inch into cracks and crevices
- Spread in a wide line across the floor
- Directly onto food containers
Show answer
The label instructions for food handling areas state to place the bait dispenser tip approximately 1/2 inch into cracks.🔗 Source
What is a required action if the gel bait contacts an exposed surface?
- Apply more gel to cover the area
- Leave it to dry naturally
- Remove the gel and wash the exposed surfaces
- Cover the surface with a repellent insecticide
Show answer
The label states that if gel bait contacts an exposed surface, you must remove the gel and wash the exposed surfaces.🔗 Source
Under what temperature condition should the bait NOT be applied to surfaces?
- Below 32°F
- Exceeding 120-130°F
- Between 70-90°F
- Exactly 100°F
Show answer
The label warns not to apply to surfaces where the temperature exceeds 120-130°F because the bait could liquefy.🔗 Source
← All practice exams