Start practice — 8 questions →
Sample questions
When applying to cracks, crevices, and voids, how should the product be applied?
- As a heavy flood to ensure saturation
- By mist, foam or spray with equipment designed for void applications
- As a dry powder dusting only
- By soaking the structural surfaces
Show answer
The label instructs to apply by mist, foam or spray with equipment designed for void applications.🔗 Source
When is the recommended timing for application?
- Only after a heavy infestation is confirmed
- At the first sign of insect pests and before the buildup of heavy pressure
- During the peak of summer heat
- Once every six months regardless of pest presence
Show answer
The label states to apply at the first sign of insect pests and before the buildup of heavy pressure.🔗 Source
What is the maximum allowable size for an indoor spot application?
- 5 square feet
- 10% of the entire treatment area
- Two square feet (2 ft. by 1 ft.)
- One square foot
Show answer
Spot treatments must not exceed two square feet in size (2 ft. by 1 ft.), not to exceed 10% of the entire treatment area.🔗 Source
When applying the product to cracks and crevices, what is the goal of the application technique?
- To ensure the product drips onto the floor for coverage
- To allow the air stream to push insecticide deep into void(s)
- To saturate the structural surfaces completely
- To create a visible residue on the surface
Show answer
The label notes to apply in short bursts to allow the air stream to push insecticide deep into void(s).🔗 Source
When performing a perimeter application outdoors, what is the required amount of Ridesco WG to be used?
- 19 grams
- 19 grams per 1,000 sq. ft.
- 57 grams
- 95 grams
Show answer
The label specifies a rate of 19 grams for outdoor perimeter applications.🔗 Source
For an indoor spot application, how much product is required to treat 1,000 sq. ft.?
- 19 grams
- 19 grams in one gallon of water
- 1 gallon of finished strength 0.15% solution
- 57 grams
Show answer
The mixing notes state using 19 grams of Ridesco WG in one gallon of water treats 1,000 sq. ft.🔗 Source
To achieve a finished strength of 0.15% for Pest Control, how many grams of Ridesco WG should be mixed in 5 gallons of water?
- 19.0 grams
- 57.0 grams
- 95.0 grams
- 190.0 grams
Show answer
The mixing instructions state 95.0 grams per 5 gallons results in a 0.15% finished strength.🔗 Source
According to the label, which of the following plant species must NOT be treated with this product?
- Oak trees
- Maple trees
- Tilia species
- Pine trees
Show answer
The restrictions state: DO NOT apply this product, by any application method, to linden, basswood or other Tilia species.🔗 Source
← All practice exams