Start practice — 8 questions →
Sample questions
What is the primary purpose of using Palisade EC on grasses grown for seed and cereals?
- To increase the height of the plant.
- To kill weeds in the wheat field.
- To shorten internodes to reduce lodging.
- To increase the amount of grain produced.
Show answer
The description states: 'It is designed to shorten the internodes in grasses grown for seed and cereals, which helps reduce lodging.'🔗 Source
What is the concentration of the active ingredient Trinexapac-ethyl in Palisade EC?
- 1 pound per gallon
- 12.0%
- 4%
- 1/2%
Show answer
The text states: 'The active ingredient is Trinexapac-ethyl at a concentration of 12.0%.'🔗 Source
Which of the following is a restriction regarding where this product may NOT be applied?
- To any area where surface water is present.
- To crops grown in greenhouses.
- To areas with high wind speeds.
- To any field containing rye.
Show answer
The label states: 'Do not apply to areas where surface water is present or to intertidal areas below the mean high water mark.'🔗 Source
Under which weather condition is application of this product prohibited?
- When wind speeds exceed 10 mph.
- In calm weather when rain is not predicted for the next 24 hours.
- During high humidity levels.
- When temperatures exceed 90 degrees Fahrenheit.
Show answer
The label states: 'Do not apply in calm weather when rain is not predicted for the next 24 hours.'🔗 Source
What is the maximum recommended height for a nozzle above the crop canopy during ground applications?
Show answer
The label states: 'Do not apply with a nozzle greater than 4 feet above the crop canopy.'🔗 Source
In the event of accidental ingestion, what instruction is provided regarding inducing vomiting?
- Induce vomiting immediately.
- Do not induce vomiting unless told to do so by a poison control center.
- Do not induce vomiting under any circumstances.
- Induce vomiting only if the person is conscious.
Show answer
The label states: 'If swallowed, do not induce vomiting unless told to do so by a poison control center.'🔗 Source
When mixing Palisade EC alone, what is the correct procedure for adding water and product to the tank?
- Add the product first, then add 1/2 to 2/3 of the water, and finally add the remaining water.
- Add 1/2 to 2/3 of the required amount of water, add the product, and then add the remaining water while continuing agitation.
- Fill the tank halfway with water, add the product, and then fill the rest of the tank with water.
- Add all the water first, then add the product and agitate.
Show answer
The label states: 'For Palisade EC alone (no tank mix), add 1/2 to 2/3 of the required amount of water to the spray or mixing tank, add the product, and then add the remaining water while continuing agitation.'🔗 Source
Which of the following is a required piece of personal protective equipment when handling this product?
- Nitrile gloves
- Chemical-resistant gloves such as barrier laminate or Viton™
- Rubber boots
- Full-face respirator
Show answer
The PPE section specifies: 'Chemical-resistant gloves (barrier laminate or Viton™)'.🔗 Source
← All practice exams