MOSQUITO MIST ULTRA 2026 03 22

MOSQUITO MIST ULTRA 2026 03 22 — 8 practice exam questions with instant feedback and cited explanations.

Practice ExamsChemicals › MOSQUITO MIST ULTRA 2026 03 22
Start practice — 8 questions →

Sample questions

Which of the following is a permitted outdoor site for treating resting or flying adult mosquitoes?

Show answer Tire piles are specifically listed as an outdoor site where adult mosquitoes occur or find harborage.

🔗 Source

When treating mosquitoes on resting or aggregation surfaces, what is the correct mixing ratio?

Show answer The label specifies mixing 0.126 oz. (3.73 ml) in one gallon of water for resting or aggregation surfaces.

🔗 Source

When applying to resting or aggregation surfaces, approximately how much area should the spray dampen?

Show answer The label notes that applying 0.126 oz. in one gallon of water should dampen approximately 700-750 square feet of treated area.

🔗 Source

To achieve an application rate of 0.0035 pounds of permethrin per acre using a backpack or handheld sprayer, what dilution must be used?

Show answer To apply 0.0035 pounds of permethrin per acre, the label requires 1 part Mosquito Mist Ultra with 5 parts of diluent.

🔗 Source

When using thermal aerosol application, what is the requirement for the spray droplets?

Show answer The label requires that 90% of the spray is contained in droplets smaller than 48 microns (Dv 0.9 < 48 µm) for thermal aerosol application.

🔗 Source

Which pests are targeted when applying the product to indoor harborage areas like utility tunnels, sewers, and basements?

Show answer For indoor harborage areas such as utility tunnels and sewers, the product targets mosquitoes, biting flies, and biting midges.

🔗 Source

When using low pressure hand sprayers, hydraulic sprayers, or ground ULV equipment for barrier applications, what is the restriction regarding water bodies?

Show answer The restrictions state not to apply within 100 feet (30 meters) of lakes and streams when using these specific application methods.

🔗 Source

What is the minimum temperature requirement for conducting all applications of this product?

Show answer The label states all applications should be conducted when temperatures are greater than 50°F.

🔗 Source

← All practice exams