Start practice — 8 questions →
Sample questions
When applying the product to a mound, what is the required application rate?
- 1 to 2 teaspoons
- 1 to 2 ounces
- 2 to 4 teaspoons
- 1 teaspoon per square foot
Show answer
The application rate for the mound site is listed as 1 to 2 teaspoons.🔗 Source
To avoid harming pollinators, when should you avoid applying this product?
- While bees are actively visiting blooming crops or weeds
- During the early morning hours
- During the late afternoon
- When the temperature is above 90 degrees
Show answer
The label prohibits application or drift to blooming crops or weeds while bees are actively visiting the area.🔗 Source
What PPE is required for Mixers, Loaders, and Applicators?
- Long-sleeved shirt, long pants, shoes plus socks, and chemical resistant gloves for mixers/loaders
- Full face respirator and chemical suit
- N95 mask and safety goggles
- Coveralls and waterproof boots only
Show answer
The label specifies long-sleeved shirts, long pants, shoes plus socks, and chemical resistant gloves for mixers and loaders.🔗 Source
For best results, when is the recommended time to apply the material?
- Early morning or late afternoon
- Midday when sun is highest
- Only during heavy rain
- At midnight
Show answer
The label recommends applying in the early morning or late afternoon when ants are most active.🔗 Source
According to the label, what is the specific target pest for this product?
- Fire Ants
- Harvester Ants only
- Bees and other pollinators
- All terrestrial insects
Show answer
The label specifically identifies Fire Ants as the target pest for the mound application.🔗 Source
Which of the following is a stated restriction regarding the location of use?
- Not for indoor residential use
- Not for use on golf courses
- Not for use on sod farms
- Not for use on any turf
Show answer
The label explicitly states 'Not for indoor residential use.'🔗 Source
Under what weather conditions might applications be ineffective?
- Prolonged hot and dry conditions
- Early morning dew
- Late afternoon humidity
- High wind speeds
Show answer
The label notes that applications under prolonged hot and dry conditions may be ineffective because ants may be deep within the nest.🔗 Source
What is the Re-entry Interval (REI) for this product?
- 24 hours
- 12 hours
- 48 hours
- 72 hours
Show answer
The label specifies a re-entry interval of 24 hours.🔗 Source
← All practice exams