Start practice — 16 questions →
Sample questions (showing 8 of 16)
Where should Fuse Termiticide be applied for a soil treatment?
- Indoor
- Outdoor
- Only inside basements
- Only under carports
Show answer
The label specifies that the soil treatment application for termites is for 'Outdoor' locations.🔗 Source
Regarding subterranean termites, how should Fuse Termiticide be used?
- To supplement soil applied termiticides, termite bait systems, or other registered products
- As the sole source of control for active, structural infestations
- As a substitute for mechanical alteration
- As a substitute for soil and foundation treatments
Show answer
The label states the product is to be used to supplement soil applied termiticides, termite bait systems, or other products registered as the sole source for termite control.Which of the following pests is Fuse Termiticide specifically listed to control?
- Wood-boring beetles
- Cockroaches
- Bed bugs
- Fleas
Show answer
The label explicitly lists wood-boring beetles as a target pest.What is the minimum distance required when applying the product near estuarine bodies of water?
Show answer
The label prohibits application within 60 ft of estuarine bodies of water.To achieve a finished strength of 0.067% using 100 gallons of water, how much Fuse Termiticide is required?
- 27.5 fl. oz.
- 55 fl. oz.
- 13.8 fl. oz.
- 5.6 fl. oz.
Show answer
The mixing instructions specify 27.5 fl. oz. per 100 gallons of water for a 0.067% finished strength.🔗 Source
When treating a concrete slab-on-ground or basement where the fill under the slab is gravel or other coarse aggregate, what is the required application rate?
- 1 gallon per 10 square feet
- 0.5 gallons per 10 square feet
- 1.5 gallons or sufficient volume per 10 square feet
- 2 gallons per 10 square feet
Show answer
The label states that if fill under slab is gravel or other coarse aggregate, apply at the rate of 1.5 gallons or sufficient volume of solution to cover 10 square feet.🔗 Source
To achieve a finished strength of 0.13% using 1 gallon of water, how much Fuse Termiticide should be mixed?
- 0.3 fl. oz.
- 0.6 fl. oz.
- 1.2 fl. oz.
- 2.8 fl. oz.
Show answer
The mixing instructions state that 0.6 fl. oz. per 1 gallon of water results in a 0.13% finished strength.🔗 Source
According to the label, what is the target pest for Fuse Termiticide?
- Ants
- Termite
- Cockroaches
- Fleas
Show answer
The label facts explicitly list 'termite' as the target pest for all applications.🔗 Source
← All practice exams