Start practice — 8 questions →
Sample questions
What is the specified finished strength range when mixing Cyper TC with water?
- 0.10% to 0.50%
- 0.25% to 1.00%
- 1.00% to 5.00%
- 5.00% to 10.00%
Show answer
The mixing and dilution section states: 'finished_strength: 0.25% to 1.00%';🔗 Source
Which target pest is CYPER TC II primarily designed to control?
- Ants and cockroaches
- Subterranean termites (including Eastern, Western, and Formosan species)
- Fleas and ticks
- Silverfish and centipedes
Show answer
The description states: 'It is primarily designed for the control of subterranean termites, including Eastern, Western, and Formosan species.'🔗 Source
When applying CYPER TC II for preconstruction termite control, where should the product be applied to the soil?
- In motor housings and junction boxes
- Around foundations, footings, and crawl spaces
- In classrooms or institutions with occupants present
- As a space spray in living areas
Show answer
The label states: 'For preconstruction, it is applied to the soil around foundations, footings, and crawl spaces.'🔗 Source
Under which weather conditions is it prohibited to apply CYPER TC II?
- When wind speeds exceed 10 mph at the nozzle end
- When temperatures are above 90 degrees Fahrenheit
- When humidity is above 80%
- When wind speeds are between 15 and 20 mph
Show answer
The label states: 'Do not apply when wind speeds exceed 10 mph at nozzle end.'🔗 Source
What is the required mixing protocol for Cyper TC when diluting with water in a tank?
- Agitate for 10-15 minutes until fully dissolved
- Mix and allow circulation for 2-3 minutes
- Mix and allow to sit for 1 hour before use
- Shake vigorously for 5 minutes
Show answer
The label states: 'Mix with water in a tank; allow circulation for 2-3 minutes.'🔗 Source
When is application of the product prohibited based on soil conditions?
- When soil is dry and dusty
- When soil is water-saturated or frozen
- When soil temperature is below 50 degrees
- When soil has been treated within the last 30 days
Show answer
The label states: 'Do not apply to water-saturated or frozen soil.'🔗 Source
Which of the following is a required component of the Personal Protective Equipment (PPE) when handling this product?
- Nitrile gloves
- Chemical-resistant gloves made of barrier laminate or viton
- Safety goggles and a respirator
- Waterproof rain coat and rubber boots
Show answer
The PPE section specifies: 'chemical-resistant gloves (barrier laminate or viton)'.🔗 Source
According to the label, which of these is a prohibited application site for this product?
- Soil around footings
- Crawl spaces
- Conduits, motor housings, or junction boxes
- Subslab voids via injection
Show answer
The use restrictions state: 'Do not use in conduits, motor housings, junction box, or electrical equipment.'🔗 Source
← All practice exams