Start practice — 8 questions →
Sample questions
What is the required application rate for Brown Patch per 1,000 sq ft?
- 0.5 to 5 fl oz
- 3 to 5 fl oz
- 4 to 7 fl oz
- 6 fl oz
Show answer
The application table lists the rate for Brown Patch as 3 to 5 fl oz/1,000 sq ft.🔗 Source
Which state has specific restrictions regarding the registration of this product for certain diseases?
- Texas
- Florida
- California
- New York
Show answer
The restrictions note that the product is not registered for use in California to control certain diseases.🔗 Source
What is the maximum allowable application rate for CHIPCO 26019T FUNGICIDE in a single application?
- 3 fl oz per 1,000 sq ft
- 5 fl oz per 1,000 sq ft
- 6 fl oz per 1,000 sq ft
- 7 fl oz per 1,000 sq ft
Show answer
The restrictions state: 'Do not exceed 6 fl oz of product per 1,000 sq ft in a single application.'🔗 Source
What is the restricted entry interval (REI) for this product?
- 12 hours
- 24 hours
- 48 hours
- 7 days
Show answer
The label specifies an REI of 24 hours.🔗 Source
According to the label, where are the intended application sites for this product?
- Indoor residential carpets
- Greenhouse vegetable crops
- Outdoor turfgrass areas
- Residential lawns
Show answer
The label states that applications are intended for outdoor turfgrass areas and specifically warns not to apply to residential lawns.🔗 Source
Which of the following diseases is CHIPCO 26019T FUNGICIDE specifically listed to control?
- Armyworms
- Pythium Blight
- Aphids
- Japanese Beetles
Show answer
The label explicitly lists Pythium Blight as one of the turfgrass diseases controlled by the product.🔗 Source
Which set of Personal Protective Equipment (PPE) is required when using this product?
- Short-sleeved shirt and shorts
- Long-sleeved shirt, long pants, and chemical-resistant gloves
- Respirator and heavy rubber apron
- Full body Tyvek suit and boots
Show answer
The PPE section requires long-sleeved shirts, long pants, and chemical-resistant gloves.🔗 Source
When treating Snow Mold, what is a critical timing/weather instruction regarding the spray mixture?
- Do not allow spray to stand for longer than 2 hours.
- Apply only during high wind conditions.
- Wait 24 hours before applying water.
- Apply only when rain is expected immediately.
Show answer
For Snow Mold, the notes state: 'Do not allow spray to stand for longer than 2 hours.'🔗 Source
← All practice exams