Start practice — 8 questions →
Sample questions
Which of the following fungal diseases is specifically listed as a target for CHIPCO 26019 FLO BRAND FUNGICIDE in turfgrass?
- Alternaria leaf blight
- Dollar Spot
- Cercospora leaf spot
- Powdery Mildew
Show answer
The label identifies Dollar Spot as a disease managed in turfgrass, while Alternaria and Cercospora are listed for ornamentals.🔗 Source
What is the application rate for Cercospora leaf spot on ornamentals?
- 3 to 4 fl. oz. per 1,000 sq. ft.
- 4 fl. oz. per 1,000 sq. ft.
- 1.0 to 2.5 oz. per gallon
- 2.5 oz. per 1,000 sq. ft.
Show answer
The label lists the rate for Cercospora leaf spot on ornamentals as 1.0 to 2.5 oz. per gallon.🔗 Source
If a technician is mixing this product with Cleary's 3339 F, what action must be taken first?
- Increase the rate by 50%
- Check compatibility before mixing
- Only mix in a drip irrigation system
- Apply as a foliar spray instead
Show answer
The mixing notes state the product is compatible with certain fungicides like Cleary's 3339 F but to check compatibility before mixing.🔗 Source
Which PPE is explicitly required for handling CHIPCO 26019 FLO BRAND FUNGICIDE?
- N95 mask only
- Chemical-resistant gloves, protective clothing, and eye/face protection
- Rubber boots and heavy apron
- Safety goggles and earplugs
Show answer
The PPE section requires chemical-resistant gloves, protective clothing, and eye/face protection.🔗 Source
What is the required application method for Alternaria leaf blight on ornamentals?
- Drip irrigation
- General turf spray
- Apply as a drip
- Tank mix only
Show answer
For ornamentals like Alternaria leaf blight, the label states to apply as a drip.🔗 Source
When treating Dollar Spot in turfgrass, what is the recommended application rate?
- 1.0 to 2.5 oz. per gallon
- 4 fl. oz. per 1,000 sq. ft.
- 3 to 4 fl. oz. per 1,000 sq. ft.
- 2 fl. oz. per 1,000 sq. ft.
Show answer
The label specifies a rate of 3 to 4 fl. oz. per 1,000 sq. ft. for Dollar Spot.🔗 Source
What is a restriction regarding the application of this product to water surfaces?
- It can be used as a water treatment if diluted 1:10
- It must only be applied to moving water
- Do not apply to water or near surface water unless specifically directed
- It is safe for all water surfaces
Show answer
The restrictions state: 'Do not apply to water or near surface water unless specifically directed.'🔗 Source
According to the label, what should a technician avoid to prevent drift?
- Applying during windy conditions
- Applying during heavy rain
- Applying near residential zones
- All of the above
Show answer
The label instructs to avoid application during windy conditions to prevent drift and to avoid drift into residential zones and water surfaces.🔗 Source
← All practice exams