Start practice — 8 questions →
Sample questions
What is the required dilution for the Bora-Care Commercial solution when treating structural wood surfaces in crawl spaces and basements?
- 1:1 Bora-Care Commercial solution
- 1:2 Bora-Care Commercial solution
- Direct application without dilution
- 1 gallon per 400 square feet
Show answer
The label states that for structural wood surfaces in crawl spaces and basements, the dilution is 1:1 Bora-Care Commercial solution.🔗 Source
When treating structural wood surfaces in crawl spaces and basements with 1 coat, how should the product be applied?
- In a 2 foot wide uninterrupted band to the point of surface saturation
- In a 2 foot band up from the concrete slab
- By injecting into holes at 8 to 10 inch intervals
- By spraying 1 gallon per 400 square feet
Show answer
For structural wood surfaces in crawl spaces and basements, the notes specify applying in a 2 foot wide uninterrupted band to the point of surface saturation.🔗 Source
When applying Bora Care to the exterior of structural wood sill areas, what is the restriction regarding multi-story structures?
- Treat only the first story above the masonry foundation level
- Treat all stories up to the roofline
- Treat only the ground level sill area
- Treat the entire perimeter of all stories
Show answer
For multi-story structures, the label instructs to treat only the first story above the masonry foundation level.🔗 Source
According to the label, what should be done with foam insulation types like polyisocyanurate and extruded polystyrene that have closed cell structures?
- Inject and surface spray
- Surface spray only
- Inject only
- Apply in a 2 foot wide band
Show answer
The label states that closed cell structures do not allow significant penetration from surface application, so you must inject and surface spray these types.🔗 Source
Which of the following is a listed storage or disposal restriction for Bora Care?
- Do not contaminate water, food or feed by storage or disposal
- Do not store in temperatures above 90 degrees
- Do not use near open flames
- Do not store in direct sunlight
Show answer
The label explicitly states: 'Do not contaminate water, food or feed by storage or disposal.'🔗 Source
When applying Bora Care to interior concrete or block foundation walls to prevent termite shelter tubes, what is the required application rate and method?
- 1 gallon per 400 square feet in a 2 foot band up from the concrete slab
- 1 gallon per 300 square feet in a 2 foot band up from the ground
- 2 foot wide uninterrupted band to the point of surface saturation
- Minimum of 2 up to a maximum of 8 inches
Show answer
The label specifies applying 1 gallon per 400 square feet in a 2 foot band up from the concrete slab for interior foundation walls.🔗 Source
If applying two coats to structural wood where access is limited to 1 or 2 sides, how much time must pass between applications?
- At least 20 minutes
- At least 1 hour
- At least 4 to 6 seconds
- Until the surface is completely dry
Show answer
The label requires allowing the first application to dry by waiting at least 20 minutes between applications for 2-coat treatments.🔗 Source
When pressure injecting Bora-Care Commercial solution into holes drilled in coated or painted structural wood, what is the specified injection time per hole?
- 4 to 6 seconds per hole
- 8 to 10 seconds per hole
- 20 minutes per hole
- 40 seconds per hole
Show answer
For coated or painted structural wood, the label specifies injecting for 4 to 6 seconds per hole.🔗 Source
← All practice exams