Start practice — 8 questions →
Sample questions
When using non-thermal, portable, motorized backpack equipment with a 50 ft. swath at 2 mph, what is the required application rate?
- 0.21 to 0.62 fl. oz. of the undiluted spray
- 0.62 Fl.oz. ANVIL per 300 ft. swath
- 1.0 to 2.0 fl. oz. per acre
- 0.42 Fl.oz. ANVIL per 300 ft. swath
Show answer
The label states the rate for backpack equipment with a 50 ft. swath is 0.21 to 0.62 fl. oz. of the undiluted spray.🔗 Source
Which of the following is a restriction regarding the use of portable backpack equipment?
- Do NOT use portable backpack equipment for application in enclosed spaces.
- Do NOT use portable backpack equipment in windy conditions.
- Do NOT use portable backpack equipment for aircraft applications.
- Do NOT use portable backpack equipment if temperatures are above 50 °F.
Show answer
The label explicitly states: 'Do NOT use portable backpack equipment for application in enclosed spaces.'🔗 Source
What is the minimum wind speed required for application according to the timing and weather instructions?
- Greater than or equal to 1 mph
- At least 5 mph
- Exactly 10 mph
- Calm air conditions
Show answer
The label specifies to 'Apply only when wind speed is greater than or equal to 1 mph.'🔗 Source
At what temperature must all types of applications be conducted?
- Above 50 °F
- Above 32 °F
- Between 60 °F and 80 °F
- Exactly 50 °F
Show answer
The label states: 'All types of applications should be conducted at temperatures above 50 °F.'🔗 Source
According to the label, which target pest is Anvil 10 10 intended to control?
- Adult mosquitoes
- Ticks and fleas
- Flies and gnats
- Termites and ants
Show answer
The label specifically identifies adult mosquitoes as the target pest.🔗 Source
When applying by fixed wing aircraft, what is the minimum height required above the ground or canopy?
- 100 feet
- 75 feet
- 50 feet
- 200 feet
Show answer
The label states not to apply by fixed wing aircraft at a height less than 100 feet above the ground or canopy.🔗 Source
If a technician prefers to dilute Anvil 10 10 ULV, which solvent should be used according to the mixing instructions?
- Light mineral oil
- Water
- Isopropyl alcohol
- Diesel fuel
Show answer
The label states that ANVIL 10+10 ULV cannot be diluted in water and should be diluted with light mineral oil if preferred.🔗 Source
To avoid phytotoxicity, what action should the technician avoid regarding foliage?
- Do not wet foliage
- Do not spray during high heat
- Do not apply to trees
- Do not apply in the morning
Show answer
The label warns: 'Do not wet foliage since oil base formulations may be phytotoxic.'🔗 Source
← All practice exams