Start practice — 8 questions →
Sample questions
What is the primary mode of action for Antik EC when controlling weeds?
- Causing desiccation through foliage absorption
- Systemic root inhibition
- Soil sterilization
- Preventing seed germination
Show answer
The label states the product is a contact herbicide that works by being absorbed through the foliage to cause desiccation.🔗 Source
Which of the following application methods is NOT listed for Antik EC?
- Aerial application
- Drip irrigation application
- Ground boom application
- Directed sprays
Show answer
The label explicitly states 'Do not apply through any type of irrigation system.'🔗 Source
Under which weather condition is it prohibited to apply Antik EC?
- Wind speeds exceeding 10 mph
- Temperatures above 90 degrees Fahrenheit
- Humidity levels below 30%
- Wind speeds below 5 mph
Show answer
The restrictions state do not apply when wind speeds are above 10 mph.🔗 Source
To prevent environmental damage, where should technicians avoid applying Antik EC?
- Near water bodies or where water is present
- In areas with high organic matter
- On sandy soil types
- During the nighttime
Show answer
The label warns to avoid drift near water bodies as the product is toxic to aquatic organisms.🔗 Source
If heavy rain is expected, how long before the rain should you avoid applying Antik EC?
- 6 to 8 hours
- 12 to 24 hours
- 2 to 4 hours
- Immediately before the rain starts
Show answer
The timing/weather instructions state to avoid application if heavy rain is expected within 6 to 8 hours.🔗 Source
According to the PPE requirements, what type of gloves must be worn?
- Chemical resistant gloves made of harder laminate or viton >= 14 mil
- Standard latex or nitrile gloves
- Leather work gloves
- Cotton fabric gloves
Show answer
The PPE section specifies chemical resistant gloves made of harder laminate or viton >= 14 mil.🔗 Source
When mixing Antik EC with water, what pH range must be maintained?
- Between 5-8
- Between 4-7
- Between 6-9
- Between 7-10
Show answer
The mixing instructions state to mix with water and maintain a pH between 5-8.🔗 Source
What must a technician do to ensure the correct application rate for a specific crop?
- Check the specific crop tables
- Use a standard rate of 1 fl oz/acre for all crops
- Apply based on the height of the weeds
- Mix the product with a pH buffer only
Show answer
The label instructs to always check the specific crop tables for precise application rates.🔗 Source
← All practice exams